Model Planes

Letov S-328 (KP-Smer kit)PE set for KP-Smer kit..

Letov S-16 (Brengun kit)PE set for Brengun kit..

Brassin set- propellers, air intakes and an undercarriage for L-410UVP in 1/72 scale. Made by direct 3D printing. Easy to assemble, replaces plastic parts. Recommended kit: Gavia / Eduard Set contains: - 3D print: 10 parts - resin: 9 parts - decals: no - photo-etched details: yes - painting mask: y..

..

Paint Mask:Preparing the masks: Masks should not be stretched during the application process as they are flexible and this could cause deformation. Remove the whole mask if necessary, and then apply again. Once placed on the model, the mask surface should be adjusted to the surface of the model ..

Paint Mask:Preparing the masks: Masks should not be stretched during the application process as they are flexible and this could cause deformation. Remove the whole mask if necessary, and then apply again. Once placed on the model, the mask surface should be adjusted to the surface of the model ..

L-749 Constellation (Heller kit)photoetched set for Heller kit..

Soviet/ Russian aircraft weapons Scale 1/72..

Preparing the masks: Masks should not be stretched during the application process as they are flexible and this could cause deformation. Remove the whole mask if necessary, and then apply again. Once placed on the model, the mask surface should be adjusted to the surface of the model by tracing all ..

Soviet/ Russian aircraft weapons Scale 1/72..

Soviet/ Russian aircraft weapons Scale 1/72..

Soviet/ Russian aircraft weapons Scale 1/72..

Soviet/ Russian aircraft weapons Scale 1/72..

Amigo models aircraft update sets Scale 1/72..

Ki-61-Id HIEN (Tamiya kit)photoetched set for Tamiya kit..

Ki-61-Id Hien Flaps (Tamiya)PE set for Tamiya kit..

Ki-61 II Kai (RSmodels92104)PE parts for RSmodels kit..

Ki-61 II Bubble top (RS model)PE parts for RS kit..

Ki-61 Id Hien Wing Racks & Drop Tanksresin set for Tamiya kit..

Ki-44 Shoki - Tojo (SWORD72042)PE accessories for SWORD kit..

KI-21 interior 3D decals for ICM kit3D Decals Instructions - Soak the decal in warm water for a few seconds. Once it separates from the backing paper, position it on the model. - For better adhesion, use white glue, Mr. Mark Setter, or apply the decal to a glossy surface. - Avoid leaving the decal ..

Ki -100-I otsu Low-back (RS92121 -92128) PE parts for RS kit RS92121 -92128..

Ki - 100-I ko - High-back (RS92126)PE parts for RS kit RS92126..