Model Planes

3D ResinThis set includes three (3) pieces that make up the belly strap found on late F-4E and all F-4G Phantoms. Designed to be used on the Revell kits, it may work on the Tamiya kit as well.The strap was also found on the F-4S and the F-4J's operated by the UK.Parts come as shown and can be ..

Vinyl Mask..

Vinyl Mask..

Vinyl Detail..

Vinyl Mask..

Vinyl Mask..

Vinyl Mask..

Vinyl Mask..

Vinyl Mask..

Vinyl Mask..

Vinyl Mask..

Vinyl Mask..

This set includes four (4) highly detailed ADU-703 adapters with BRU-32 bomb racks for use on the Tamiya, Revell and Trumpeter 1/32 F-14A/B/D kits. Modification to the kit weapons rails will be necessary. Drawings with measurements on where to cut are provided.Released in cooperation with our frie..

Vinyl Mask..

3D ResinThis set includes twenty four (24) DSU-33 Proximity Fuzes. These are designed to work with all kit supplied bombs that may not have accurate or clean versions...

This set includes four (4) octagon shaped drip pans commonly found under aircraft, both on the flightline and in hangar spaces. Great for use in dioramas to add a little bit more realism to your scene.Parts come as shown in photo. Very light sanding needed on one surface needed prior to painting...

This set includes eight (8) corrected Pitot Tubes for use on the F/A-18A thru D, F-14A/B/D, A-7D/E and F-8E.Directly replaces kit parts in the Academy, Tamiya and Trumpeter kitsCAD by Dave Roof..

3D ResinThis set includes one travel pod for use on all USN/USMC F-4 Phantom kitsCAD by Craig Sargent..

Designed for the GBU-31 with BLU-109 warhead included in the Academy F-16D and F-16I kits..

3D ResinThis set includes twelve (12) BDU-33 25lb practice bombs...

3D ResinThis set includes six (6) SATCOM Antenna with short mount found on a number of Helicopters. Use fine sprue cutters to remove part from support and lightly sand base smooth. Attach using super glue (CA)...

This set includes eight (8) wing pylons, one (1) centerline pylon, seven (7) BRU-36 ejector racks, and two (2) LAU-138 BOL launchers.3D printed and designed by Richard VanZandt using photos and measurements provided by FLD, Simon Oakes, Robert Foster and David Sweetman..

This set includes eight (8) wing pylons, one (1) centerline pylons, and seven (7) BRU-36 ejector racks.3D printed and designed by Richard VanZandt using photos and measurements provided by FLD, Simon Oakes, Robert Foster and David Sweetman..

This set includes six (6) wing pylons, two (2) centerline pylons*, seven (7) BRU-36 ejector racks and two (2) adapters used when the LAU-7 missile launcher is attached to the outboard pylons.*Different centerline pylons are configured for use with the strakes or gun pack.3D printed and designed..