Model Planes

How-to:Preparing the masks: Masks should not be stretched during the application process as they are flexible and this could cause deformation. Remove the whole mask if necessary, and then apply again. Once placed on the model, the mask surface should be adjusted to the surface of the model by traci..

#NOTE: The set does NOT include a model kit...

This set is primary focused to the Eduard F6F Hellcat kits in the 1/48 scale.It consists from 27 resin parts and one photo-etched fret.The engine block is molded separately, also as each cylinder and air intake. The propeller reducer is separate as well, also as two pieces of engine housing covers.T..

Water-slide Decals: Instruction: 1. Preparation: to achieve better result, a gloss or semi-gloss coat is very important. It will make a smooth layer which the decals will suction to and make it much easier to apply and set them. 2. Cut out the decal you need (do it on cutting mat) 3. Grab the d..

..

Brassin set - pilot seat for P-51B or P-51C in 1/48 scale. Made by direct 3D printing. Easy to assemble, replaces plastic parts.Recommended kit: Eduard Set contains: - 3D print: 1 part - decals: no - photo-etched details: no - painting mask: no..

..

..

This product contains a die-cut flexible foil for masking a kit or section of a kit during the painting of a scale plastic model. When selecting this set make sure that it is for the kit recommended as these sets are made specifically for that kit.How-to:Preparing the masks: Masks should not be stre..

How-to:Preparing the masks: Masks should not be stretched during the application process as they are flexible and this could cause deformation. Remove the whole mask if necessary, and then apply again. Once placed on the model, the mask surface should be adjusted to the surface of the model by traci..

..

..

..

..

..

..

..

..

How-to:Preparing the masks: Masks should not be stretched during the application process as they are flexible and this could cause deformation. Remove the whole mask if necessary, and then apply again. Once placed on the model, the mask surface should be adjusted to the surface of the model by traci..

..

..

..

..

..