Model Planes

When the Japanese Zero first entered service in 1940, it was without doubt the most advanced naval fighter in the world and quickly earned a reputation as a ruthless dogfighter. In early engagements, the Zero proved so effective that pilots were able to post an almost unbelievable victory ratio of 1..

..

yellow kabuki paper..

..

..

**NOTE:Slight warpage might occurred to the malleable nature of white metal and is easily straightened. A brief but succinct tutorial for working with white metal can be found on the homepage the their official website: www.scaleaircraftconversions.com..

Paint Mask:Preparing the masks: Masks should not be stretched during the application process as they are flexible and this could cause deformation. Remove the whole mask if necessary, and then apply again. Once placed on the model, the mask surface should be adjusted to the surface of the model ..

Mirage 2000D interior 3D decals forModelSvit kit3D Decals Instructions - Soak the decal in warm water for a few seconds. Once it separates from the backing paper, position it on the model. - For better adhesion, use white glue, Mr. Mark Setter, or apply the decal to a glossy surface. - Avoid leavi..

Mirage 2000C interior 3D decals forModelSvit kit3D Decals Instructions - Soak the decal in warm water for a few seconds. Once it separates from the backing paper, position it on the model. - For better adhesion, use white glue, Mr. Mark Setter, or apply the decal to a glossy surface. - Avoid leavi..

Mirage 2000 exhaust nozzle for Modelsvit kit (3D Printed) (1/72)..

Mirage 2000 exhaust nozzle for Italeri/Revell kit (3D Printed) (1/72)..

..

..

..

This is a plastic model kit, which comes unassembled and unpainted. So glue, model paints and other basic modelling tools are additionally required...

This is a plastic model kit, which comes unassembled and unpainted. So glue, model paints and other basic modelling tools are additionally required...

Paint Mask:Preparing the masks: Masks should not be stretched during the application process as they are flexible and this could cause deformation. Remove the whole mask if necessary, and then apply again. Once placed on the model, the mask surface should be adjusted to the surface of the model ..