Alclad ALC-111 Regular Finishes - Magnesium 1oz/30ml

APPLICATION GUIDE-PLASTIC MODELS: For use on injection plastic kits a primer is necessary. 'Regular ALCLAD' is similar in strength to lacquer/cellulose car paints-injected polystyrene plastics frequently have areas which ALCLAD can craze. High-Shine ALCLAD finishes require a glossy base coat.

Apply one of these primers before using Regular ALCLAD:
- ALCLAD GREY PRIMER ALC-302
- Tamiya or Gunze Sangyo plastic primers
- Auto Primer-white or grey

Plastic primers and auto primers should be lightly polished with 1000/1200 wet & dry paper to give a less absorbent smooth surface .

PREPARATION AND SPRAYING
The surfaces to be painted must be thoroughly clean and free from dust,grease,oil and finger marks. Apply the correct primer for the type of Alclad being used.

ALCLAD should be sprayed at 12-15psi. Spray from a distance of 2-3 inches from the surface being painted using a narrow to medium width spray fan. Use the airbrush like a paint brush-aim to cover the model in a methodical manner.
Buffing is not necessary-tonal variation can be made by polishing selected panels with Micromesh. REGULAR ALCLAD can be masked over and painted. Decal solutions can be used with REGULAR ALCLAD, but are not recommended for HIGH SHINE ALCLAD

The PRISMATIC finishes require a dark base coat-use ALCLAD GLOSS BLACK BASE. Apply 2-3 light coats. When completely dry finish with 2-3 coats of ALCLAD CLEAR BASE. ALCLAD HOLOMATIC SPECTRAL CHROME should be applied over ALCLAD GLOSS BLACK BASE. Apply 1-2 light coats. When completely dry finish with 2-3 coats of WATER BASED CLEAR.

NOTE: Due to its Highly Flammable purpose, all alclad products can only be shipped within Australia. Thanks for your understanding.