Print Scale 48-076 1/48 Cessna A/T-37 Dragonfly Decals

Type: Water-slide decals

1.??essna A-37B Dragonfly of the 524th Fighter Squadron, 62nd Tactical Wing 2nd Air Division located at Nha Trang during 1969. The A-37B gradually replaced the A-1 as the VNAF??s main fighter-bomber.
2. ??essna A-37B Dragonfly of the 516th Fighter Squadron,41st Tactical Wing, 1st Air Division based at Da Nang during June of 1970. The A-37s was developed especially for small ai

How to apply water-slide decals:
1. Preparation: to achieve better result, a gloss or semi-gloss coat is very important. It will make a smooth layer which the decals will suction to and make it much easier to apply and set them.
2. Cut out the decal you need (do it on cutting mat)
3. Grab the decal with tweezers, place it on the surface of the water and leave it for about 20 seconds.
4. Remove the decal from the water and place it on paper towel to remove any excess water.
5. Apply decal solution to the part where the decal is to be placed.
6. Slide the decal off the backing paper on to the model. Using a paint brush or cotton bud is a good way to do this without damaging the decal.
7. Use the brush, knife or cotton bud to position the decal. Using your paper towel, gently dab the decal and soak up the excess water (decal softner is also recommended at this stage. After applying softner, the decal will suction to the part and flatten out smooth.)
8. When the decal is completely dry, give another coat of varnish or Klear/Future to seal it.