Print Scale 72-088 1/72 Sikorsky H-34 Decals

Type: water-slide decals

1. CH-34A Choctaw (54465) US ARMY Medevac 1960.

2. US Coast Guard HUS-1G (later designation H-34G), serving in the New Orleans area, early 1960.

3. UH-34D BUNO.148771 HMM-362 ?UGLY ANGELS?, 1966 Vietnam.

4. HMM-363 UH-34D 148077 (c/n 58-1191) in Alaska to support VQ-1 and the Army Security Agency. (Photo courtesy of the author?s collection).

5. Sikorsky UH-34D Seahorse, US Marines, BuAer 148062, HMM-364, MCAS Tustin CA, ca 1965.

6. UH-34D Seahorse (150219) YP20 HMM-163 Vietnam 1967.

7. Sikorsky HSS-1N Seabat, US Navy, BuAer 147990, HS-7, CVS-15 USS Randolph, ca 1962.

8. Sikorsky HSS-1 Seabat, US Navy, BuAer 143930, HS-4, CVS-37 USS Princeton, ca 1959.

How to apply water-slide decals:
1. Preparation: to achieve better result, a gloss or semi-gloss coat is very important. It will make a smooth layer which the decals will suction to and make it much easier to apply and set them.
2. Cut out the decal you need (do it on cutting mat)
3. Grab the decal with tweezers, place it on the surface of the water and leave it for about 20 seconds.
4. Remove the decal from the water and place it on paper towel to remove any excess water.
5. Apply decal solution to the part where the decal is to be placed.
6. Slide the decal off the backing paper on to the model. Using a paint brush or cotton bud is a good way to do this without damaging the decal.
7. Use the brush, knife or cotton bud to position the decal. Using your paper towel, gently dab the decal and soak up the excess water (decal softner is also recommended at this stage. After applying softner, the decal will suction to the part and flatten out smooth.)
8. When the decal is completely dry, give another coat of varnish or Klear/Future to seal it.