Print Scale 72-156 1/72 Wet Decals - Avro Anson (1 sheet)

Type: water-slide decals
1. Avro Anson Mk.l, K6285/MW-F, No.321 Squadron RAF, 1940.
2. Anson Mk.I Part: 220 Sqn, RAF Coast Command No.: H-220 (N6211).
3. Anson Mk.I Part: Escadrille Arras, Groupe Artios No.: EG352.
4. Avro Anson Mk.l W1530, RAAF. Dark Earth/Foliage Green uppersurfaces and white undersides; blue/white roundels in six
positions. Red crosses under wings and fuselage, the latter within a white disc, red lower half of cowlings; serial in light grey.
5. Avro Anson Mk.I, OT-ZCB (Na5), No. 21 Squadron (15 Transport Wing) Belgian Air Force. Aluminium overall with national markings in six positions code and serial in black. In July 1947, the Belgian Government acquired 11 Avro Anson Mk. I
communications aircraft from RAF surplus stocks. Anson I NA-5/OT-ZCB remained in service of the 21st squadron of the 15th Transport wing until May 1955.
6. Avro Anson Mk.l, AW665/PP-B, No. 71 Squadron, RAAF.

How to apply water-slide decals:
1. Preparation: to achieve better result, a gloss or semi-gloss coat is very important. It will make a smooth layer which the decals will suction to and make it much easier to apply and set them.
2. Cut out the decal you need (do it on cutting mat)
3. Grab the decal with tweezers, place it on the surface of the water and leave it for about 20 seconds.
4. Remove the decal from the water and place it on paper towel to remove any excess water.
5. Apply decal solution to the part where the decal is to be placed.
6. Slide the decal off the backing paper on to the model. Using a paint brush or cotton bud is a good way to do this without damaging the decal.
7. Use the brush, knife or cotton bud to position the decal. Using your paper towel, gently dab the decal and soak up the excess water (decal softner is also recommended at this stage. After applying softner, the decal will suction to the part and flatten out smooth.)
8. When the decal is completely dry, give another coat of varnish or Klear/Future to seal it.