Techmod 48815 Decals for 1/48 Potez 63-11 (260 x 180mm)

Type: water-slide decals Scale: 1/48 Decals Manufacturer: TECHMOD Sheet Size: 260×180mm

Potez 63-11 c/n 420 (AX691), French Fighter Flight No.2, Haifa (Palestine), February 1941 Potez 63-11 c/n 395 (AX680), French Fighter Flight No.2, Haifa (Palestine), October 1940 Potez 63-11 c/n 670 (AX673), French Fighter Flight No.2, Ismailia, Egypt, December 1940 Potez 63-11, RC+ZF, Luftwaffe Potez 63-11, 101, Royal Rumanian Air Force, 1942 Potez 63-11, 71, Royal Rumanian Air Force, 1942 Hungarian Potez 63-11, KH+TH (Luftwaffe markings), Aviation Research Institute, Topoca Airfield, Summer 1944 Hungarian Potez 63-11, KH+TF (Luftwaffe markings), Aviation Research Institute, Ferihegy Airfield, Spring 1944

How to apply water-slide decals:
1. Preparation: to achieve better result, a gloss or semi-gloss coat is very important. It will make a smooth layer which the decals will suction to and make it much easier to apply and set them.
2. Cut out the decal you need (do it on cutting mat)
3. Grab the decal with tweezers, place it on the surface of the water and leave it for about 20 seconds.
4. Remove the decal from the water and place it on paper towel to remove any excess water.
5. Apply decal solution to the part where the decal is to be placed.
6. Slide the decal off the backing paper on to the model. Using a paint brush or cotton bud is a good way to do this without damaging the decal.
7. Use the brush, knife or cotton bud to position the decal. Using your paper towel, gently dab the decal and soak up the excess water (decal softner is also recommended at this stage. After applying softner, the decal will suction to the part and flatten out smooth.)
8. When the decal is completely dry, give another coat of varnish or Klear/Future to seal it.