HGW 148528 1/48 Remove Before Flight (Laser Cut)

Seat belts, suitable for plastic scale aircrafts, are made from micro-plastic foil. In combination with attached photo etched buckles this accesorry looks highly realistic. These are available in 1/48 scale and for more comfortable work they are pre-cut.

- microplastic sheeting, metallic buckles
- it is possible to make seat belts fully functional - un/buckle, un/fasten them
- made by special microplastic foil which is printed and behaves like a rag
- microplastic parts are prepared to using filters - it leads to darkening shades - and these are also waterproofedand resistant to normal nonaggresive modeller preparations
- photo-etched parts were developed in cooperation with Eduard company

Instructions:
1. Take the precut textile part out of the sheet
2. Remove supporting paper
3. Crumple the belt into a little ball and knead it between the fingers
4. Thread the belts through the buckles - use superglue
5. Put the belts into the seat
6. Spray by the glossy varnish
8. Spray by matt varnish
7. Impregnate the belts with very diluted oil colour (mix of black and brown) - it will highlight the tex