Print Scale 72-427 Decals for 1/72 Mitsubishi A6M Zero-Sen Aces Part 2

1. A6M2 Model 21 "S-171, Houkoku-437" of FPO3c Hideo, Watanabe, Chitose Kokutai's fighter hikotai, Wake Island, April 1942.
2. A6M2 Model 21 "X-182" of Lt Zenjiro Miyano, 3rd Kokutai, Poeleti (Penfui), Timor, March 1942.
3. A6M2 Model 21 "F-108" of FPO1c Hiroyoshi Nishizawa, 4th Kokutai, Lae, New Guinea, March 1942.
4. A6M2 Model 21 "V-158" of FPO2c Susumi Ishihara, Tainan Kokutai, Denpasar airfield, Bali, March 1942.
5. A6M2 Model 21 "V-141, Houkoku-439" of FPO2c Yoshisuke Arita, Tainan Kokutai, Denpasar airfield, Bali, March 1942.
6. A6M2 Model 21 "V-138" of Lt (jg) Jun-ich Sasai, Tainan Kokutai, Lakunai, Rabaul, August 1942.
7. A6M2 Model 21 "V-172" (construction number 5784) of FPO1c Saburo Sakai, Tainan Kokutai, Lakunai, Rabaul, August 1942.
8. A6M3 Model 32 "Q-102, Houkoku-872" (construction number 3030) of FCPO Kazu-o Tsunoda, 2nd Kokutai, Buna, Papua New Guinea, August 1942.
9. A6M2 Model 21 "V-103" (construction number 3647) of FCPO Tora-ichi Takatsuka,Tainan Kokutai, Lakunai, Rabaul, September 1942.
10. A6M3 Model 32 "X-151, Houkokui-994" of F1c Kiyoshi lto, 202nd Kokutai, Kendari, Celebes, November 1942.

Water-slide Decals:
Instruction:
1. Preparation: to achieve better result, a gloss or semi-gloss coat is very important. It will make a smooth layer which the decals will suction to and make it much easier to apply and set them.
2. Cut out the decal you need (do it on cutting mat)
3. Grab the decal with tweezers, place it on the surface of the water and leave it for about 20 seconds.
4. Remove the decal from the water and place it on paper towel to remove any excess water.
5. Apply decal solution to the part where the decal is to be placed.
6. Slide the decal off the backing paper on to the model. Using a paint brush or cotton bud is a good way to do this without damaging the decal.
7. Use the brush, knife or cotton bud to position the decal. Using your paper towel, gently dab the decal and soak up the excess water (decal softner is also recommended at this stage. After applying softner, the decal will suction to the part and flatten out smooth.)
8. When the decal is completely dry, give another coat of varnish or Klear/Future to seal it.