White Ensign Models PE2020 1/200 Assorted Ships Ladders Set (1 Photo-Etched Sheet)

1. Do not remove the photo-etched parts from the fret until you are ready to use them.
2. Before assembly, soak the etched parts in a suitable solvent, such as white spirit, to de-grease the surfaces for painting. It is recommended that the entire fret be primed with an acrylic automotive primer, such as Halfords Grey Primer before assembling any of the parts.
3. Cyanoacrylate adhesive (super glue) or contact adhesive such as a white PVA glue may be used. These can be applied with a pin or piece of stretched sprue.
4.When removing parts from the fret, place the fret on a hard surface, such as a smooth ceramic tile, in order to prevent parts bending whilst cutting through the holding tabs. WEM suggests that using a No.10 rounded type of modelling knife blade for this purpose.
5. When shaping or bending a part, a straight edged blade such as a chisel blade will give a good sharp corner. If a part is bent incorrectly, lay it on a hard flat surface and roll it flat with a cylindrical object such as a modelling knife handle.