Barracuda BC-72232 1/72 Messerschmitt Bf 109G-6/G-14 Decals Part 1

This sheet features 7 interesting Gustavs with a wide array of colours and markings. Thoroughly researched by Anders Hjortsberg, who also created the stunning profile artwork, these are the culmination of years of research, and represent the latest thinking in colour and markings. This sheet features full colour instructions, 2 full sets of stencils and enough national markings to do at least 2 aircraft.

Bf 109G-6. White Chevron of III./JG1 flown by Friedrich Eberle at Eelde. October 1943

Bf 109G-6. Black 10 of IV./JG54, Dorpat, Soviet Union (Estonia), early 1944.

Bf 109G-6. + - of II./JG11, flown by Gunther Specht, Germany. February 1944

Bf 109G-6. Yellow 6, of 9./JG3, Normandy, July 1944 Bf 109G-14. White 21 of Franz Wienhusen, Gruppenkommandeur IV./JG4, autumn 1944.

Bf 109G-6. Blau 62 of JG 110, Finow, Germany. Early spring 1945

Bf 109G-6. Gelbe 20 of 3./EKG(J), Ansbach, Germany. March 1945

How to apply water-slide decals:
1. Preparation: to achieve better result, a gloss or semi-gloss coat is very important. It will make a smooth layer which the decals will suction to and make it much easier to apply and set them.
2. Cut out the decal you need (do it on cutting mat)
3. Grab the decal with tweezers, place it on the surface of the water and leave it for about 20 seconds.
4. Remove the decal from the water and place it on paper towel to remove any excess water.
5. Apply decal solution to the part where the decal is to be placed.
6. Slide the decal off the backing paper on to the model. Using a paint brush or cotton bud is a good way to do this without damaging the decal.
7. Use the brush, knife or cotton bud to position the decal. Using your paper towel, gently dab the decal and soak up the excess water (decal softener is also recommended at this stage. After applying softener, the decal will suction to the part and flatten out smooth.)
8. When the decal is completely dry, give another coat of varnish or Klear/Future to seal it.