Echelon Fine Details D356249 Decals for 1/35 IDF AML-90
Thorough researched markings based on the only good known source - the unit itself, which recently posted in-service images. The registration number stylings are exactly for the sixties period of service and also used by other vehicle types. The two known locations for vehicle registration plates are lower front (fills up the entire lower surface area) and rear hull left.
Also included are two sets of pre-cut turret roof identification white "T" bands, as number of vehicles clearly had those. 3 versions of barrel rings (various thickness). Last but not least, the all-important PSI tire pressure stencils in Hebrew.
Water-slide Decals:
Instruction:
1. Preparation: to achieve better result, a gloss or semi-gloss coat is very important. It will make a smooth layer which the decals will suction to and make it much easier to apply and set them.
2. Cut out the decal you need (do it on cutting mat)
3. Grab the decal with tweezers, place it on the surface of the water and leave it for about 20 seconds.
4. Remove the decal from the water and place it on paper towel to remove any excess water.
5. Apply decal solution to the part where the decal is to be placed.
6. Slide the decal off the backing paper on to the model. Using a paint brush or cotton bud is a good way to do this without damaging the decal.
7. Use the brush, knife or cotton bud to position the decal. Using your paper towel, gently dab the decal and soak up the excess water (decal softener is also recommended at this stage. After applying softener, the decal will suction to the part and flatten out smooth.)
8. When the decal is completely dry, give another coat of varnish or Klear/Future to seal it.
Also included are two sets of pre-cut turret roof identification white "T" bands, as number of vehicles clearly had those. 3 versions of barrel rings (various thickness). Last but not least, the all-important PSI tire pressure stencils in Hebrew.
Water-slide Decals:
Instruction:
1. Preparation: to achieve better result, a gloss or semi-gloss coat is very important. It will make a smooth layer which the decals will suction to and make it much easier to apply and set them.
2. Cut out the decal you need (do it on cutting mat)
3. Grab the decal with tweezers, place it on the surface of the water and leave it for about 20 seconds.
4. Remove the decal from the water and place it on paper towel to remove any excess water.
5. Apply decal solution to the part where the decal is to be placed.
6. Slide the decal off the backing paper on to the model. Using a paint brush or cotton bud is a good way to do this without damaging the decal.
7. Use the brush, knife or cotton bud to position the decal. Using your paper towel, gently dab the decal and soak up the excess water (decal softener is also recommended at this stage. After applying softener, the decal will suction to the part and flatten out smooth.)
8. When the decal is completely dry, give another coat of varnish or Klear/Future to seal it.
General Info | |
Scale | 1/35 |
Type | Model Upgrade/Accessory |
Subtype | Decals / Stickers |
- Stock: Out Of Stock
- Reward Points: 12
- SKU: EC D356249
Echelon Fine Details
MRP: US$10.09 Save: US$2.14
21% OFF
US$7.95
(excl. Tax)
"In-Stock" Really Means It
Combine Shipping & Save
SAME or Next day shipping*
There are no reviews
Maybe you can help? Many users will be grateful to you. And so are we.