Print Scale 72-162 1/72 Wet Decals - Aerospatiale SA.330 Puma

Type: water-slide decals

1. SA.330L Puma, AE-508, Stanley airport, Falklands Islands 1982.

2. SA.330B Puma, 67-DC, Operation Daguet, Iraq 1991.

3. IAR-330L Puma, 49, Kecskemet , Hungary 2013.

4. SA.330H Puma, 175, Pretoria, South Africa 2014.

5. SA.330L Puma, HD19-3, (1254), Palma de Mallorca, Spain 2014.

6. Puma HC.1 , XW231, RAF 230 Squadron, RIAT 2005, Fairford, UK 2005.

7. Puma HC.1 , XW222, RAF 33 Squadron, Vilnius, Lithuania 2006.

How to apply water-slide decals:
1. Preparation: to achieve better result, a gloss or semi-gloss coat is very important. It will make a smooth layer which the decals will suction to and make it much easier to apply and set them.
2. Cut out the decal you need (do it on cutting mat)
3. Grab the decal with tweezers, place it on the surface of the water and leave it for about 20 seconds.
4. Remove the decal from the water and place it on paper towel to remove any excess water.
5. Apply decal solution to the part where the decal is to be placed.
6. Slide the decal off the backing paper on to the model. Using a paint brush or cotton bud is a good way to do this without damaging the decal.
7. Use the brush, knife or cotton bud to position the decal. Using your paper towel, gently dab the decal and soak up the excess water (decal softener is also recommended at this stage. After applying softener, the decal will suction to the part and flatten out smooth.)
8. When the decal is completely dry, give another coat of varnish or Klear/Future to seal it.